Dynojet Oxygen Sensor Eliminator Honda CB 1000 R, CBR 600 F 01-06, CBR 600 RR 03-04, VFR 800 98-08

Dynojet Oxygen Sensor Eliminator for Honda Models.
This connector allows you to exclude or manage oxygen sensor, where and 'present, to prevent it from interfering with the action of the Dynojet Power Commander, avoid sending error signals in the original unit, which would (in some cases) to enable the security mode that limits engine power curve.

On motorcycles of the latest generation are installed one or more oxygen sensors that have the function of communicating to the original control the amount of oxygen present in the exhaust gas.
The original control unit is programmed to comply with anti-pollution regulations such that the air / fuel ratio must be thinner than what would be the optimum for the correct operation of the engine.

If you install an additional unit Dynojet Power Commander without excluding / disable the original lambda probe will not be able to totally control the fuel mixture as the original unit would perform continuous corrections.

The Dynojet Oxygen Sensor Eliminator (O2 eliminator) is installed in place of the original sensor probe (one or more depending on the model of bike) and Replaces.

This connector you can 'install even without the use of the Power Commander, on some models entails no improvement on other models helps you to fatten up the fuel mixture without facing significant cost.

This article is not approved, the elimination of the oxygen sensor affect the compliance of the emissions of exhaust gases to the legislation and is therefore to be considered for use only on road racing or otherwise not open to the public.